Abstract
The growth in energy demand for natural gas has led to the exploration of sub-quality natural gas reserves with high CO2 content up to 80% at the offshore condition with temperature and pressure approximately 50 °C and 70 bar. In this work, a gravimetric technique is used to study CO2 and CH4 adsorptions on 13× zeolites at 50 °C and up to 70 bar pressure as an adequate range for offshore operations. 13× zeolite shows high CO2 adsorption capacity with 5.226 mmol/g at 50 °C compared to 4.29 mmol/g at 70 °C. The same trend is noticed for CH4 adsorption on both temperatures. Four equilibrium isotherm models are used to analyze the adsorption data i.e. Langmuir, Freundlich, Toth, and Sips. Virial isotherm model is applied on the experimental data to illustrate the isosteric heat of adsorption and it shows an excellent agreement with R2 = 0.998 for 13× MSZ. Henry's law constant is estimated utilizing Virial coefficients, which shows higher molar selectivity ratio for CO2 on 13× with α ˜ 3.957 at 50 °C as compared to the α ˜ 3.736 at 70 °C. Extended Langmuir (EL) Model and Multisite Langmuir (MSL) models are applied for 30:70, 50:50, and 70:30 CO2:CH4 binary mixtures. The outcomes of MSL exhibit high agreement with the quadrupole and polarizability of the single component and the mixtures. The kinetic rate constant is estimated according to the applied LDF model at higher operational regions. The 13× MSZ shows feasibly good isosteric heat of adsorption, which might refer to the large surface area and pore volume that can accommodate CO2 at higher speed and quantity at offshore conditions.
[Display omitted]
•In this work, CO2 and CH4 adsorption on 13× zeolites at 50 and 70 °C temperatures and up to 70 bar pressure were studied under an adequate range for offshore conditions.•The maximum adsorption of CO2 observed on 13× was 5.226 mmol/g at 50 °C compared to 4.29 mmol/g at 70 °C.•Henry's law constant measured by utilizing Virial coefficients showed higher selectivity for CO2 on 13× with (α∼3.957).•EL and MEL models showed feasible outcomes with lower adsorption for binary CO2:CH4 mixtures compared to pure components uptakes and 13× showed Qst (13.75 kJ/mol) at higher operational conditions.