Abstract
Long-term in situ measurements of aerosol-cloud interactions are usually performed in measurement stations residing on hills, mountains, or high towers. In such conditions, the surface topography of the surrounding area can affect the measured cloud droplet distributions by increasing turbulence or causing orographic flows and thus the observations might not be representative for a larger scale. The objective of this work is to analyse, how the local topography affects the observations at Puijo measurement station, which is located in the 75m high Puijo tower, which itself stands on a 150m high hill. The analysis of the measurement data shows that the observed cloud droplet number concentration mainly depends on the cloud condensation nuclei (CCN) concentration. However, when the wind direction aligns with the direction of the steepest slope of the hill, a clear topography effect is observed. This finding was further analysed by simulating 3-D flow fields around the station and by performing trajectory ensemble modelling of aerosol-and wind-dependent cloud droplet formation. The results showed that in typical conditions, with geostrophic winds of about 10 m s(-1), the hill can cause updrafts of up to 1 m s(-1) in the air parcels arriving at the station. This is enough to produce in-cloud supersaturations (SSs) higher than typically found at the cloud base of similar to 0.2 %), and thus additional cloud droplets may form inside the cloud. In the observations, this is seen in the form of a bimodal cloud droplet size distribution. The effect is strongest with high winds across the steepest slope of the hill and with low liquid water contents, and its relative importance quickly decreases as these conditions are relaxed. We therefore conclude that, after careful screening for wind speed and liquid water content, the observations at Puijo measurement station can be considered representative for clouds in a boreal environment.