Abstract
The influence of lightweight expanded clay aggregate (LECA) on the physico-mechanical properties and microstructure of geopolymer mortar containing slag binder alkali-activated with sodium silicate solution before and after exposure to thermal loads was investigated. In the current procedure, siliceous sand was partially substituted with LECA fine aggregate at levels of 0%, 25%, 50%, 75%, and 100%, by volume. The effect of LECA on the performance before exposure was evaluated by measuring flowability, water absorption, bulk density, thermal conductivity, and compressive strength. To monitor the behavior after exposure, a batch of specimens having the same composition was subjected to high temperatures in the range of 400-1000 degrees C for 2 h with a heating rate of 5 degrees C/min. In a similar fashion, mass loss and residual compressive strength were determined. New phase-based geopolymers were examined using Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM). The findings indicated that the incorporation of LECA up to 100% as an alternative to siliceous sand aggregate in geopolymer mortar has an adverse effect on compressive strength and water absorption, but has a positive effect on workability, thermal conductivity, and relative strength after exposure to elevated temperatures.