Abstract
Rapid industrialization has exposed the human community to serious risks of water toxicity from excessive contamination of fresh water by toxic dyes. Thus, many techniques have been adopted to reduce water contamination. Adsorption technology based on environmentally friendly adsorbents appears to be the best solution; mixed metal-oxide nanocomposites as adsorbents have been in great demand over the past several years. Mixed metal-oxide nanocomposites can be modified using biodegradable materials to meet this demand, although such studies are very rare. This study reports the preparation of phthalic-acid-modified copper-zinc binary oxide coupled with a nickel hydroxide nanocomposite. Copper-zinc binary-oxide-coupled nickel hydroxide nanocomposite was prepared by a simple co-precipitation method and modified with biodegradable phthalic acid. The characterization results revealed the enhanced functional groups and porosity of phthalic-acid-modified nanocomposite, which was used to remove Congo red dye and found to be more suitable than unmodified copper-zinc binary-oxide-coupled nickel hydroxide. Congo red dye removal efficiency of the modified nanocomposite was approximately 30% higher than that with the unmodified nanocomposite under the same conditions. Approximately 2.0 g/L amount of the modified nanocomposite adsorbent could remove about 99% of the 10.0 mg/L concentration of Congo red dye within 120 min at pH = 7.0 and 30 degrees C. The partition coefficient (similar to 32.00 mg/g/mu M), equilibrium adsorption capacity (similar to 5.00 mg/g), and maximum adsorption capacity (similar to 20.0 mg/g) of the modified nanocomposite were also found to be much better than those of the unmodified copper-zinc binary-oxide-coupled nickel hydroxide and other reported adsorbents. The regeneration and reusability test results of the modified nanocomposite for Congo red dye removal suggested that the modified adsorbent was efficient for five cycles. This pioneering study is shown to be efficient for wastewater treatment, and the novelty is based on the use of biodegradable acids. Based on experimental results, it is recommended that more biodegradable acids be used in adsorbent preparation and modification in the future so that sustainable and affordable technologies may be achieved.