Abstract
Medical microwave imaging (MWI) research has gained more attention in recent dec-ades, particularly with regard to the early detection of brain tumors. It offers numerous benefits over existing imaging technologies, including magnetic resonance imaging (MRI) and computed tomography (CT) scans. Antennas represent a key element of MWI systems, so optimizing their performance is critical. A new, simple patch antenna for MWI is presented in this article. The radi-ating patch has a circular slot and a tiny triangular cut at the top right corner, and it is designed and manufactured with a low-cost FR4-epoxy substrate with a loss tangent of 0.02 and a dielectric con-stant of 4.4. The overall dimensions are 0.28X, x 0.22X, x 0.005X, (where X, is the wavelength of a lower frequency of 1.22 GHz). A total impedance bandwidth (<-10 dB) of 2.23 GHz (1.22- 3.45 GHz) is achieved with a very decent gain of above 5 dBi (measured) and above 85 % efficiency over the functional range. Time-domain assessment of the antenna confirms minimum signal distortion and shows a better response in terms of group delay (GD) and fidelity factor (FF, 92 %). Measurements confirm the results from simulations (CST and HFSS) with a reasonable degree of agreement. Finally, the 3D-electromagnetic CST simulator was utilized to analyze the behavior of a nine-antenna array placed around a 3D-realistic Hugo-head model; it yielded satisfactory results and proved the practical utility of the proposed antenna in the intended MWI application.(c) 2022 THE AUTHORS. Published by Elsevier BV on behalf of Faculty of Engineering, Alexandria University. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/ licenses/by-nc-nd/4.0/).