Abstract
Metallic and alloy particles are recognized as alternatives to ceramic reinforcements to improve the overall characteristics of Al metal matrix composites. The present study aimed to investigate the friction stir processing/manufacturing of the 316 stainless steel particles reinforced AA6061 Al matrix composites by varying the tool rotational speeds. The microstructure, tensile, hardness, wear, corrosion behavior, and shear punching tests of the composites were studied. The results showed that the friction stir processing route produced no particle-matrix reaction in the composite and dislocation entanglements were formed close to the inherent 316 stainless steel particles within the Al matrix. The improved mechanical action of the tool aided particle fragmentation as the average 316 stainless steel particle sizes decreased from 41.88 to 26.89 μm. As a result of the dynamic recrystallization and particle-assisted pinning effects, the mean grain sizes of the composite decreased from 7.48 to 4.31 μm when the tool rotational speed was raised. An increment in the tool rotational speed (800–1200 rpm) triggered a rise in the maximum shear force (1198–1562 N), tensile strength (200.09–279.98 MPa), and maximum hardness value (121–139 HV) of the composite while a favorable decrease in the composite's wear rate (0.63–0.20 mg/m) and the friction coefficient (0.38 ± 0.01–0.21 ± 0.01) ensued. The composite's improvement is attributable to the homogeneous spread of dislocation.
•The manufacturing of the 316 stainless steel reinforced AA6061 Al matrix composites was investigated via the use of the friction stir processing technique.•A smoother surface appearance is produced as the tool rotational speed is increased from 800 to 1200 rpm due to improved material flow/flowability aided by the increased frictional heat input.•Better 316 SS particle dispersion is achieved in the composites as the tool rotational speed is increased beyond 800 rpm.•No particle-matrix reaction ensued in the FSP'ed. composites despite the changes in the tool rotational speed.•The maximum shear forces of composite improved from 1198 to 1562 N as the rotational speed is increased from 800 to 1200 rpm due to the fine 316 SS particle-induced dislocation strengthening.