Abstract
Nanocrystalline barium hexaferrite (BaFe12O19) powders have been synthesized through the co-precipitation route. The produced ferrite precursors were obtained from aqueous mixtures of barium and ferric chlorides by co-precipitation of barium and iron ions using 5 M sodium hydroxide solution at pH 10 in room temperature. These precursors were calcined at temperatures of 800-1200 degrees C for constant 2 h in a static air atmosphere. The effect of Fe3+/Ba2+ mole ratio and addition of surface-active agents during co-precipitation step on the crystal structure, morphology and magnetic properties of produced ferrite powders were studied. The results obtained showed that the single phase BaFe12O19 powders was achieved by decreasing the Fe3+/Ba2+ molar ratio from the stoichiometric value 12 to 8 and increasing the calcination temperature >= 1000 degrees C. In addition, the Fe3+/Ba2+ mole ratio of 8 and presence of surface-active agents promoted the formation of homogeneous nanopowders (ca. 113 nm) of BaFe12O19 at a low temperature of 800 degrees C with good saturation magnetization (50.02 emu/g) and wide coercivities (642.4-4580 Oe). (c) 2006 Elsevier B.V. All rights reserved.