Abstract
Aim: The objective of this laboratory study was to analyze the effect of different grit-blasting pressures on adhesion of resin to silica-coated and silanized Ti using the shear bond test.
Materials and methods: A total of 24 commercially pure grade 2 Ti coupons (1 mm x 20 mm x 40 mm) were prepared and randomly assigned to 4 groups based on surface treatment: 150 kPa grit -blasting pressure with Rocatec (TM) Soft (group 1) for 10 s. Similarly, groups 2, 3 and 4 were treated at 280 kPa (control), 330 kPa and 380 kPa grit-blasting pressures, respectively, and followed by silanization. A total of 10 resin stubs per group were bonded onto each treated surface with photopolymerization. The shear bond strength was measured after 24 h dry storage in a desiccator, 2 months H2O storage, and 4 months H2O storage. Data were analyzed using descriptive statistics and two-way ANOVA (p < 0.05).
Results: After 24 h, initial SBS values of tested groups were significantly higher (32.0% for group 1, 39.1% for group 3, and 23.9% for group 4) than the control (group 2). After artificial aging, SBS values decreased in all the groups. The highest adhesion strength was seen in 150 kPa (13.0 +/- 3.0) and 280 kPa (4.9 +/- 2.4) after 2 months, and 4 months artificial aging, respectively.
Conclusion: A lower grit -blasting pressure might promote adhesion strength in long term water aging. (C) 2015 Elsevier Ltd. All rights reserved.