Abstract
A simple, fast, economic and environmental friendly method has been developed for the preparation of high active metal nanoparticles (MNPs) in the cellulose microfibers of cotton (CFC). The CFCs are kept in aqueous solutions of metal salts to adsorb metal ions. The CFC templated with metal ions are then treated with aqueous solution of NaBH4 for the reduction of metal ions into nano zero-valent metal nanoparticles (nZV-MNPs). The CFC loaded with nZV-MNPs are characterized by XRD, XPS, ATR-FTIR and FE-SEM, which indicates the successful synthesis of nZV-MNPs over the surface of CFC (M@CFC). The M@CFC are utilized as an efficient catalyst for the hydrogen generation from the methanolysis/hydrolysis of NaBH4. The Cu@CFC showed better catalytic performance for the hydrolysis of NaBH4, whereas Ag@CFC catalytic performance were much better than the other loaded MNPs for the methanolysis reaction of NaBH4. Effects of different parameters, which affecting the H-2 generation, like type of MNPs, amount of the catalyst, amount of NaBH4, temperature and addition of chitosan (CH) polymer are also investigated. A very low activation energy (Ea), approximately 20.11 +/- 0.12 kJ mor(-1) for methanolysis reaction of NaBH4 is calculated at temperature range 22-40 degrees C. Besides, a very high H-2 generation obtained in presence of 10, 50, or 100 mu L CH solution (2 wt% CH in 20% v/v aqueous acetic acid) in addition to 50 mg of Ag@CFC catalyst at 22 degrees C and 1000 rpm. Moreover, the reusability of the catalyst is performed and found no decrease in percent conversion, whereas percent activity decreases 35% after four cycles. (C) 2018 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.