Abstract
This paper reports an experimental investigation on continuous CO2 laser cutting of pol-ymethylmethacrylate (PMMA) sheet. The influence of four process factors (laser power, cutting speed, assisting gas pressure and sheet thickness) on five process responses (kerf deviation, top heat affected zone, bottom heat affected zone, maximum surface roughness and rough area) has been investigated. The experimental plan was established based on Taguchi L18 mixed design. The kerf geometry and heat affected zones have been measured using polarising light microscopy technique, while the surface roughness was evaluated using 3D laser scanning confocal microscope. Regression models have been derived to correlate different process responses with different process factors. The cut surface could be classified into three zones: rough zone, moderate zone and soft zone. The rough area is increased by increasing gas pressure and laser power and by decreasing the sheet thick-ness and cutting speed. Increased kerf deviation has been observed at high cutting speed, laser power and gas pressure. High laser power and low cutting speed produced worst surface roughness and wide heat affected zone. Therefore, it is recommended to use low laser power and high cutting speed to minimize the heat affected zone and the surface roughness. However, increasing the cutting speed may result in high kerf deviation. (C) 2021 The Author(s). Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).