Abstract
Aluminum alloys AA7075-T6 and AA5083-H111 were friction stir welded at constant rotation rate of 300 rpm and different traverse speeds of 50,100, 150, and 200 min/min in similar and dissimilar joints. The microstructures and crystallographic textures of base materials (BM) and the welds were investigated using electron backscatter diffraction (EBSD) technique. The mechanical properties were evaluated using hardness and tensile testing. The fracture surface of the tensile tested samples was examined Using scanning electron microscope (SEM). Microstructural examination of AA7075 and AA5083 BMs showed significant difference in the grain structure of the two alloys with average grain size of 40 mu m that was free of substructure in case of AA7075. While AA5083 BM revealed an average grain size of 25 mu m with high density of substructure. In addition the type precipitates also are different in the two alloys. Although, the two alloys welded using the same FSW parameters the two alloys exhibited different response in terms of the recrystallized fine grains after FSW. Significant grain refining occurred in the NG zone of AA7075 with average grain size of 6 mu m at 50 min/min welding speed that was reduced to 2 mu m by increasing the welding speed to 200 mm/min. A relatively recrystallized coarser grain structure obtained in AA5083 joints NG zone with average grain size of 9 mu m at 50 mm/min that is reduced to 3 mu m at 200 min/min. This implies that the starting material characteristics have a significant impact on the final grain structure after FSW. The crystallographic texture in the nugget zone revealed a simple shear texture without a significant influence of varying the welding speed. The dissimilar joints exhibited ultimate tensile strength ranged between 245 and 267 MPa and fracture strain ranged between 3 and 5.6%.A brittle/ductile fracture mode was dominating in the examined fracture surface of the dissimilar joints. (C) 2016 Elsevier B.V. All rights reserved.