Abstract
Methylammoniumn lead iodide perovskites have attracted great attention in photovoltaic research community. In this work, we demonstrate the results of studies focusing on the chemical reaction of CH3NH3PbI3-xClx layer formation during the annealing of perovskite precursor films. We identified two kinds of grain morphologies during the formation of perovskite films grown from non-stoichiometric precursor solution. To form single-phase and high absorbance perovskite films, higher concentration of chloride in precursor solution needs longer annealing time and only a very low Cl content could be incorporated in the final CH3NH3PbI3-xClx films. Adding PbCl2–3CH3NH3I to PbI2–CH3NH3I precursor solution can allow a good control of the growth rate and morphology for the final perovskite film, and is beneficial to the photovoltaic performance of perovskite devices. By employing the precursor solutions of PbCl2, PbI2 and CH3NH3I with a mole ratio of 1:1:4 and inserting an ultrathin amino-functionalized polymer interlayer, we achieved planar perovskite solar cell with maximum power conversion efficiency of over 15%.
[Display omitted]
•Phase transformation dependence of annealing time has been studied in detail.•The effect of the PbCl2 concentrations in the precursor solution is investigated.•PbCl2 could be used to control the growth rate and morphology of perovskite films.•The optimal device achieves a power conversion efficiency of over 15%.