Abstract
► Both the alloy toughness and fracture behavior are influenced by some parameters. ► Heat treatment or controlling Mg content can enhance alloy impact toughness. ► Impact property is determined by Al
2Cu phase and not by eutectic Si particles. ► The high cooling rates improve the impact toughness. ► Increasing Mg content than 0.3wt% did not lead to a noticeable change in toughness.
Critical automotive applications using heat-treatable alloys are designed for high impact toughness which can be improved using a specified heat treatment. The alloy toughness and fracture behavior are influenced by the alloy composition and the solidification conditions applied. The mechanical properties of alloys containing Cu and Mg can also be enhanced through heat treatment. The present study was undertaken to investigate the effects of Mg content, aging and cooling rate on the impact toughness and fractography of both non-modified and Sr-modified Al–Si–Cu–Mg base alloys. Castings were prepared from both experimental and industrial 319 alloy melts containing 0–0.6wt% Mg. Test bars were cast in two different cooling rate molds, a star-like permanent mold and an L-shaped permanent mold, with dendrite arm spacing (DAS) values of 24 and 50
μm, respectively. Test bars were aged at 180
°C and 220
°C for 2–48
h. Charpy Impact test was used to provide the impact energy. It was observed that high cooling rates improve the impact toughness whereas the presence of Cu significantly lowers the impact properties which are determined mainly by the Al
2Cu phase and not by the eutectic Si particles. The addition of Mg and Sr were also seen to decrease the impact toughness. The crack initiation energy in these alloys is greater than the crack propagation energy, reflecting the high ductility of Al–Si–Cu–Mg base alloys.