Abstract
The objective of this paper is to investigate the effect of Multi-Walled Carbon Nanotubes (MWCNTs) content on microstructure and dry sliding wear behavior of hypo-eutectic A356Al-Si alloy Metal Matrix Nano-Composites (MMNCs). Composites containing 0.5, 1.5, and 2.5wt.% MWCNTs were prepared by rheocasting technique followed by squeeze casting. Characterization of nanocomposites was done by scanning electron microscopy (SEM) equipped with energy dispersive X-ray analysis (EDX), dry sliding wear tests were performed in a pin-on-disk wear tester against a steel disk at various speeds and normal loads. Results revealed that a decrease in both wear rate and friction coefficient of the nanocomposites considerably with the increase of MWCNT's content. The formation of the hard compact transfer layer on the pin surface nanocomposites assisted in increasing the wear resistance of these materials. It is that the transfer layer which was formed under an applied load of 20N can act as a protective layer and help in reducing the wear rate. The results indicate the nano composites could be used in light-weight applications where moderate strength and wear properties are needed.