Abstract
Objective:
The aim of this study was to evaluate marginal fit of yttrium tetragonal zirconia polycrystals (Y-TZP)' copings with different finish line designs fabricated with various digital scanners and milling systems.
Methods:
Three model plastic teeth were prepared with three finish line designs: Design-1, continuous chamfer; Design-2, chamfer with shallow depression; Design-3, chamfer with deep depression. The "master models" were replicated using elastomeric polyvinyl siloxane impression material and poured in type IV stone generating 90 dies, 30 dies for each design. Dies were scanned and copings were milled utilizing three digital scanners and computer-aided design/computer-aided manufacturing (CAD/CAM) systems: System-1, InEos Red Scan (Sirona Dental Systems, Germany), Vitablocks (R) Mark II (VITA, Germany) copings milled by Cerec (R) inLab (Sirona Dental Systems, Germany); System-2, Cerec (R) AC Connect with BlueCam (Sirona Dental Systems, Germany), Vitablocks (R) Mark II (VITA, Germany) copings milled by Cerec (R) inLab (Sirona Dental Systems, Germany); and System-3, NobleProcera (TM) Optical Scanner (NobleBiocare (TM)), procera zirconia coping milled by a Noble Procera (TM) milling machine (NobleBiocare (TM)). Copings were seated on their respective "master models" and secured with uniform force. Eight measurements per coping were performed at pre-established points, with a metallurgical microscope (Zeiss, Germany) connected to a high precision digital video-micrometer (Javelin JV6000, California, USA) at 200 x magnification.
Results:
The tested systems demonstrated marginal gaps ranging from 12.4 to 26.6 mu m. Results for marginal fit of milled copings fabricated using three systems with different finish line designs differed significantly (p < 0.05). Procera zirconia copings scanned and milled with NobleProcera (TM) exhibited significantly lower marginal gaps compared to other specimen groups. However, InEos Red Scan/Vitablocks (R) Mark II/Cerec (R) inLab showed maximum marginal gaps among the study specimens.
Conclusions:
CAD-CAM manufactured Y-TZP' copings exhibited marginal gaps ranging from 12.49 to 26.6 mu m. The CAD-CAM fabrication system was a significant factor influencing the marginal misfit of Y-TZP' copings. Margin design exhibited system dependent influence on the marginal misfit. Marginal misfit observed for all systems were within clinically acceptable parameters.