Abstract
► The effects of the chemical composition, the microstructure, and the morphology of second phase particles on the mechanical and machinability properties of new experimental alloy namely 396 alloy were investigated. ► The morphology of Si particles has a noticeable effect in governing the tool life of near-eutectic Al–Si alloys. ► The Mg-free experimental alloy displays the lowest cutting force and moment in addition to producing the highest number of holes. ► The increase in the levels of Cu and/or Mg in the 396-T6 alloy has a detrimental effect on drill life.
This study was conducted with the intention of investigating a new experimental alloy, namely the 396 alloy which belongs to the Al–Si near-eutectic cast alloy group and contains about 10.8%Si. In the light of the above, the main purpose of the work is to report on the changes observed in the mechanical and machinability criteria resulting from the effects of the presence of two levels of Cu, namely 2.25% and 3.5%; and of the effects of two levels of Mg, namely 0.3% and 0.6%. In addition to the preceding, the effects of Mg-free alloys and Sr-modification on these same alloys were also investigated.
The results demonstrate that the increase in the levels of Cu and/or Mg in the 396-T6 alloy has a detrimental effect on drill life. Such an effect may be attributed to the formation of large amounts of the coarse blocklike Al2Cu phase, together with the formation of thick plates of the Al–Si–Cu–Mg phase. The Mg-free experimental alloy displays the lowest cutting force and moment in addition to producing the highest number of holes in the alloys studied. This observation may be explained by the cooperative precipitation of the Al2Cu, Mg2Si, Al2CuMg, and Al5Si6Cu2Mg8 hardening phases in Mg-containing alloys which confer greater strength on the alloy than would be the case with the precipitation of only the Al2Cu phase in the Mg-free alloy. A comparison of the non-modified alloy and the Sr-modified alloy (containing the same level of Mg and Cu additions) in terms of the number of holes drilled, reveals that the morphology of Si particles has a noticeable effect in governing the tool life of near-eutectic Al–Si alloys. The chip breakability of the alloys containing the Al2Cu phase is superior to that of the alloys containing Mg2Si. Thus, combined additions of Cu and Mg are expected to further refine the size of the chips produced.