Abstract
Friction stir spot welding of high-Mn twinning-induced plasticity steel was studied. Welds were made at different tool rotation speeds and constant plunge rate and dwell time. The microstructure evolution was examined by optical microscopy, scanning electron microscopy and electron backscattered diffraction technique. In addition, the microhardness distribution and tensile-shear load bearing capacity were measured. The friction stir spot welding process successfully produced high integrity completely defect-free joints at all the proposed welding parameters. However, the complex plastic deformation and high thermal cycle experienced had a significant effect on the weld region, which consisted of three distinct zones. The flow transition zone, stir zone and torsion zone were all characterized by a recrystallized grain structure. The heat affected zone was characterized by a coarse grain structure as a result of grain growth caused by the high thermal cycles experienced. The hardness was significantly affected by friction stir spot welding, resulting in a softened region in the joint area. The softening increased as the rotation rate increased. The maximum peak tensile shear load of 13kN was obtained at 750rpm, and a considerable amount of extension was obtained in all the joints with a maximum of 4mm at 500rpm.
In the present study a detailed investigation of the microstructures of friction stir spot welded high-Mn twinning induced plasticity steel using OM, SEM and EBSD is carried out. [Display omitted]
•The friction stir spot welding of high-Mn twinning induced plasticity (TWIP) steel was studied.•The FSSW process produced completely defect-free, high integrity joints at all the parameters examined.•HAZ has a coarse grain structure as a result of grain growth due to high thermal cycles experienced.•The maximum peak tensile shear load of 13kN was obtained at 750rpm.