Abstract
This paper employs the general finite element software ABAQUS to numerically model the behaviour of restrained structural subassemblies of steel beam to concrete filled tubular (CFT) columns and their joints in fire. The simulations were conducted using 3-D brick elements to enable detailed structural behaviour to be obtained. For validation, this paper compares the simulation and test results for the three fire tests using reverse channel connection recently conducted at the University of Manchester. This comparison demonstrates that the 3-D finite element model is able to successfully simulate the fire tests. Afterwards, the validated finite element model was used to conduct a preliminary numerical study to investigate the feasibility of changing some of the connection details to enhance survivability of the structure in fire. Specifically, this investigation concentrated on developing connection methods to enable catenary action in the connected beam to be more fully developed. An example is to develop a hybrid flush/extended endplate and flexible endplate connection in which the tension part of the connection uses a flush/extended endplate for increased tensile resistance but the compression part of the connection uses a flexible endplate for improved ductility. It has been found that, without additional cost, using a hybrid extended/flexible endplate connection to replace a flush endplate connection has the potential to enable the connected beam to survive significantly increased temperature. (C) 2011 Elsevier Ltd. All rights reserved.