Abstract
The performance of vacuum membrane distillation (VMD) modules can be optimized through careful selection of design parameters. The present study examines how the addition of cylindrical filaments in the feed channel increases momentum mixing and the overall performance of VMD modules under different operating inlet conditions. Three-dimensional transient Computational Fluid Dynamics (CFD) simulations are conducted using Wall-Adapting Local Eddy-Viscosity (WALE) subgrid-scale Large Eddy Simulation (LES) turbulence model. Local concentration, temperature, and flux are coupled at the membrane surface to predict the rate of water vapor diffused through the membrane by Knudsen and viscous diffusion mechanisms. The predicted and measured vapor flux agrees reasonably well; validating the employed model. The small-scale eddies induced by the presence of spacer filaments promote mixing in the module, thus the temperature and concentration polarization is alleviated and the water vapor flux is immensely improved. The insertions of filaments in the feed channel increase the water permeate rate by more than 50% at higher feed flow rates and inlet temperatures. The pressure drop by the spacer reduces the allowable module length by one order of magnitude, but the module length increases two folds at feed temperature 80 degrees C. Even though the power consumption of the module containing the filaments is increased, the addition of filaments is strongly recommended since the required power for the process could be supplied from readily available low-grade heat source.