Abstract
This article presents the use of the rotary ultrasonic machining process for drilling holes in Ti6Al4V alloy which is regarded as a difficult-to-cut material due to its high-temperature strength and low thermal conductivity. This research presents an experimental investigation on the effect of the key rotary ultrasonic machining input parameters including ultrasonic power, spindle speed, feed rate, and the tool diameter on the main output responses including cutting force, hole cylindricity and overcut errors, and tool wear. No previous reports were found in literature to experimentally investigate the effect of the rotary ultrasonic machining parameters and the tool diameter on tool wear, surface integrity, and the accuracy of the drilled holes in Ti6Al4V alloy. The results showed that the rotary ultrasonic machining input parameters within the current ranges can significantly affect the quality of the drilled holes. Through proper selection of input parameters, holes could be drilled in Ti6Al4V alloy with smoothed surface morphology, low tool wear (0.7mg) and very low cylindricity (2 mu m) and overcut (120 mu m) errors. Moreover, it was found that the selected level of any input parameter has the ability to significantly affect the influence of the other input parameters on the output responses.