Abstract
We present a detailed analysis and computations of the emitted radiation spectrum for quantum dots (QDs) microcavity light-emitting device, where the total physical thickness of the cavity spacer was kept at 254 nm which corresponds to the wavelength of the mode number (m) = 1 resonant mode of the cavity. Our calculation gives good results for QD diameter only from 1.2 to 6.4 nm. The computations are used to examine how the emitted radiation spectrum can be optimized by varying the position of the light-emitting layer, the type of cathode material, the choice of hole transport layer material, and the thickness of electron transport layer, QD layer, and hole transport layer. These studies showed that the variation of layers geometry and the position of the light-emitting layer will optimize the output intensity and the radiation spectrum and varying the ETL and QD layer thickness will have a more effect on the emitted spectrum than varying HTL thickness. In addition, we have examined the effect of using different quantum dots sizes in emission layer. On the other hand, we have investigated the difference between the electroluminescence (EL) emissions for microcavity device in comparison with the non-cavity device, and we have found that the full width at half maximum (FWHM) of the EL is reduced from 45 nm for the QD non-cavity LED to 30 nm for the output of a resonant microcavity device. Finally, we have investigated the compatibility between our calculation and the experimental results and found a fairly good agreement between them.