Abstract
The effects of Fe2O3 doping of NiO/MgO system on its surface and catalytic properties were investigated. The amount of NiO was fixed at 16.6 mot% and those of Fe2O3 were varied between 1.03 and 7.69 mot%. Pure and doped solids prepared by wet impregnation method were precalcined at 300-1000degreesC. The techniques employed were XRD, nitrogen adsorption at -196 degreesC, H2O2 decomposition at 30-50degreesC and conversion of isopropanol at 200-500degreesC. The results revealed that NiO dissolved completely in MgO lattice at temperature greater than or equal to 800 degreesC forming NiO-MgO solid solution. The doping process conducted at 300 and 500 degreesC effected a measurable increase in its specific surface area (SBET), total pore volume (V-p) and mean pore radius reaching to maximum limits at certain dopant concentration above which the S-BET and Vp suffered a sudden decrease. This treatment effected also, a measurable decrease the particle size and degree of ordering of detected MgO phase. A portion of Fe203 added to NiO/MgO system conducted at 800- 1000 degreesC interacted readily with the catalyst constituents yielding MgFe2O4 and NiFe2O4 phases. Fe2O3-treatment conducted at 300 and 500degreesC brought about an increase of 442 and 675% in the catalytic activity towards H2O2 decomposition expressed as reaction rate constant per unit surface area (kappa(-)) measured at 30degreesC. The doping process did not modify the mechanism of H2O2 decomposition but rather increased the concentration of active sites contributing in reaction. In isopropanol. pure and variously doped solids behave as dehydrogenation and dehydration catalysts leading to the formation of conversion. acetone and propene. The effects of Fe2O3 on the activity and selectivity towards acetone and propene formation were studied and the results showed that the activity and selectivity are dependent on precalcination temperature and dopant concentration. (C) 2003 Published by Elsevier B.V.