Abstract
Polymer coatings are widely used to protect metals from corrosion. Coating adhesion to the base material is critical for good protection, but coatings may fail because of cathodic delamination. Most of the experimental studies on cathodic delamination use polymers to study the corrosion behavior under conditions where the interfacial chemistry at the metal(oxide)/polymer interface is not well-defined. Here, ultrathin linear and cross-linked poly(methyl methacrylate) [PMMA] coatings that are covalently bound to oxide-covered zinc via a silane linker have been prepared. For preparation, zinc was functionalized with vinyltrimethoxysilane (VTS), yielding a vinyl monomer-covered surface. These samples were subjected to thermally initiated free radical polymerization in the presence of methyl methacrylate (MMA) to yield surface-bound ultrathin PMMA films of 10-20 nm thickness, bound to the surface via Zn-O-Si bonds. A similar preparation was also carried out in the presence of different amounts of the cross-linkers ethylene glycol diacrylate and hexanediol diacrylate. Functionalized and polymer-coated zinc samples were characterized by infrared (IR) spectroscopy, secondary ion mass spectrometry (SIMS), ellipsometry, and X-ray photoelectron spectroscopy (XPS). Coating stability toward cathodic delamination has been evaluated by scanning Kelvin probe (SKP) experiments. In all cases, the covalently linked coatings show lower delamination rates of 0.02-0.2 mm h(-1) than coatings attached to the surface without covalent bonds (rates similar to 10 mm h(-1)). Samples with a higher fraction of cross-linker delaminate slower, with rates down to 0.03-0.04 mm h(-1), compared to similar to 0.3 mm h(-1) without cross-linker. Samples with longer hydrophobic alkyl chains also delaminate slower, with the lowest observed delamination rate of 0.028 mm h(-1) using hexanediol diacrylate. For the coatings studied here, delamination kinetics is not diffusion limited, but the rate is controlled by a chemical reaction. Several possibilities for the nature of this reaction are discussed; radical side reactions of the oxygen reduction are the most likely path of deadhesion.