Abstract
Two inorganic coatings, namely 88%WC-12%Co (PSC1) and 86 /01ATC-10%Co-4%Cr (PSC2), were deposited on the surface of an API-2H pipeline steel using high velocity oxy-fuel deposition. The corrosion of the uncoated and coated API-2H steel after their immersion in a solution of 4.0% NaC1 for 1 h, 24 h, and 48 h has been studied. Various electrochemical measurements such cyclic potentiodynamic polarization, electrochemical impedance spectroscopy, and potentiostatic current versus time were employed. The surface morphology and analysis were carried out via the use of scanning electron microscopy and energy dispersive X-ray examinations. All experiments have revealed that the deposited coatings decreased the cathodic current, anodic current, corrosion current density (j(Corr)), absolute current versus time, and the corrosion rate (Rcon) compared to the uncoated API-2H steel. The value of j(Corr) decreased from 47 1.1 mu A/cm(2) for uncoated steel to 38 1.1 mu A/cm(2) for the PSC1-coated steel and 29 1.1 mu A/cm(2) for the PSC2-coated steel. Moreover, prolonging the time of exposure decreases the jcorr and Rcon values. The jcorr values obtained after 48 h recorded 32, 26, and 20 1.1 mu A/cm(2) for the uncoated, PSC1, and PSC2 samples, respectively. Moreover, applying these coatings also led to increasing the corrosion resistance (Rp) after all the exposure periods of time. In addition, the PSC2 coating was found to be more protective against corrosion for the surface of the steel than the PSC1 coating.