Abstract
A wideband hemispherical dielectric resonator antenna (DRA) with enhanced gain is proposed for a frequency band of 20 to 28 GHz. The precise alignment and assembly of the DRA represent key challenges at such frequencies that were addressed using three approaches: the first was based on outlining the DRA position on the ground plane, the second involved creating a groove in the compound ground plane in which the DRA is placed, and the third was based on the 3D-printing of the DRA on a perforated substrate. In all cases, the same DRA was utilized and excited in a higher-order mode using an annular ring slot. The high gain was achieved by exciting a higher-order mode, and the wideband was obtained by merging the bandwidths of the two excited modes. The alignment methods used expedite the DRA prototyping by saving substantial time that is usually spent in adjusting the DRA position with respect to the feeding slot. The proposed configurations were measured, with an impedance bandwidth of 33.33% and a maximum gain of 10 dBi observed. Close agreement was achieved between the measured and simulated results.